IllustrationA container crossing the Arabian Sea reaches 60 degrees C inside, and the packing that survives the warehouse does not survive that without planning.
In short
- A container to the Gulf swings from 60 to 25 degrees C daily, so pack for that, not for a warehouse.
- Seal each panel in a 0.05 mm poly bag with 10 to 20 g of desiccant per square metre of surface.
- Use ISPM 15 heat treated pallets; untreated wood is refused at Gulf ports.
Furniture that leaves a Chinese factory in good condition can arrive in Jebel Ali with a swollen edge, a bleached panel and a crushed corner. The damage is not usually caused by rough handling. It is caused by thirty days inside a steel box that heats to 60 degrees C by day and cools to 25 by night, at 65 to 75 percent relative humidity.
In short: seal every panel in a poly wrap with a desiccant bag, use five layer corrugated with hard corner boards, keep the container floor dry, and load heavy units at the bottom. Assume a 12 to 15 degree C daily swing and design the packing for it.
What does the container actually do to wood?
Two things. Heat softens the lacquer for several hours each day, so any tape or label pressed onto a finished face leaves a mark that cannot be polished out. Moisture from the wood itself and from pallets condenses on the inner steel wall at night and drips onto the top layer. Over 30 days that cycle is enough to swell a poorly sealed edge band and to bleach a veneer that has no UV protection in its lacquer.
How should panels be packed?
First, seal the panel in a 0.05 mm poly bag with 10 to 20 grams of desiccant per square metre of surface. Second, EPE foam on the face, 3 mm minimum. Third, hard corner protectors on all four corners, because corners take the drop. Fourth, five layer corrugated carton with a printed handling mark. Fifth, stack no more than three high unless the unit is designed for it.
What about pallets and phytosanitary rules?
Use heat treated wood marked with the ISPM 15 stamp. Untreated pallets are refused at Gulf ports and the whole container can be held. If the project uses plywood crates, confirm the crate wood is also treated. Keep the pallet height under 150 mm so a standard forklift can lift it, and leave 100 mm between the carton top and the container roof for air movement.
How is the container loaded?
Heavy items - desks, vanities with stone tops - go on the floor and along the centre line, light items above and at the doors. Lash every stack with strapping to the container lashing points; a 20 mm shift per day over 30 days adds up to a crushed front panel. Leave the doors accessible without unloading the whole container, and photograph the loading pattern, because the site team will unload it in a different order.
What to check before the doors close?
Moisture content of the packed wood, ideally under 10 percent. Desiccant quantity calculated and recorded per container. Container floor dry and free of water stains, which indicate a leaking roof. Photographs of each layer. And a seal number recorded on the packing list, so a dispute can be traced to a container rather than a shipment.
What belongs in the packing specification? 1. Poly wrap thickness and desiccant quantity. 2. Foam type and thickness on faces and edges. 3. Carton grade and corner protection. 4. Pallet treatment and ISPM 15 marking. 5. Stack height limit and lashing method. 6. Loading sequence and photographic record.
The limitation: packing protects a panel, it does not protect a finish from thirty days of heat. If the project needs a gloss finish that cannot take 60 degrees C, ship it in a ventilated container or accept that a small percentage will need site repair.