IllustrationOld veneer and lacquer have aged for a decade, so an exact match is not possible; what a renovation needs is a measured, approved approximation.
In short
- Measure the existing panel on its least sun exposed face, then record the instrument and light source.
- Accept 2 to 3 delta E in a renovation, and confirm the panel under the room's own lighting.
- If old and new sit side by side in a visible run, replace the run or build a deliberate break.
A renovation brief usually says match the existing finish. It is an instruction nobody can fully obey, because the existing finish has spent ten years changing colour. What the project actually needs is a documented, approved approximation, plus a plan for the rooms where the old and the new will sit side by side.
In short: measure the old panel with a colour instrument, take the reading on the least sun exposed face, accept 2 to 3 delta E, and decide in writing whether to match or to replace the whole visible run in a single room.
Why does the old finish no longer match its own record?
Three ageing processes. Nitrocellulose and solvent PU lacquers yellow with UV exposure, most on the side facing a window. Natural veneer darkens or fades depending on species, and a cherry veneer shifts by several units over a decade. And cleaning chemicals slowly change the surface gloss, usually downward. A 2010 panel measured in 2026 is a different colour from the sample that was approved in 2010, and both are the original.
Which face should be measured?
The one that gets the least sun. A wardrobe back panel or a door that stays closed. Reading the sunlit face gives a colour that any new panel will fail against in a north facing room. Take three readings per element and use the average, and record the instrument model, the light source setting and the date, since a future dispute will need all three.
Where should the new finish be accepted?
At 2 to 3 delta E, and only under the lighting of the room it will sit in. Delta E under 2 is usually invisible but expensive to achieve on an aged reference. Above 4 and nobody will believe it matches. If the room has a 2700 K lamp and the approval happens under daylight, the same panel reads 2 units warmer after installation.
When should matching be abandoned?
When the joint between old and new falls in the middle of a visible run, such as a wardrobe bay beside a retained wardrobe. Two panels at 3 delta E side by side look mismatched even when they measure within tolerance. In that case, either replace the whole run in that room or install a deliberate break, such as a contrasting panel or a 10 mm reveal, so the eye reads it as a joint rather than a failure.
How should the specification handle it?
Define three scopes per room: retained items, replaced items, and items retained with a new finish. Require a physical comparison panel per scope, photographed beside the existing panel under the room lighting. Set the tolerance in numbers per scope, because a guest room can absorb 3 delta E on a back panel and cannot on a door front.
What about gloss and texture, not just colour?
Measure gloss too. A 30 gloss new panel beside a 12 gloss aged one reads as two different materials regardless of colour, because the reflection pattern differs. If the existing is matte and open grained, a filled and polished new panel will never look like it belongs. Texture matching matters more than a half unit of colour.
What belongs in the renovation finish clause? 1. Scope per room: retained, replaced, refinished. 2. Colour readings with instrument and light source recorded. 3. Accepted delta E per scope. 4. Gloss reading and accepted range. 5. Comparison panel requirement under room lighting. 6. Joint treatment where old meets new.
The limitation: if the retained furniture is more than fifteen years old and already refinished once, matching becomes guesswork with a real budget. In that case the cheaper answer is often to replace the visible items and keep the rest out of sight.